Genuine Volkswagen Golf SportWagen Door Lock Cylinder

Volkswagen Golf SportWagen Door Lock Cylinder Parts and Q&A

• Lock Cylinder
  107-837-167-CL
  Q: How to replace the door lock and door lock cylinder on Volkswagen Golf SportWagen?

  A:

  To fit in a new lock cylinder, one must first remove the lock cylinder cover on the outside door handle and the lock cylinder. Unlock the door of the driver, disassemble the rubber access plug, the locking bolt and loosen the retaining bolt of the lock cylinder then unlock the lock cylinder body within the door. On the outside handle, the entire handle should be pulled towards the back of the door until the release mechanism is disconnected and the entire handle pulled out with an electrical connector being disconnected in case it is present. Secondly, to remove the latch and outside handle bracket, you need to remove the door trim panel and then remove the lock cylinder and outside door handle. Take out the inner door access panel, window glass, motor and regulator. Unplug the electrical connector of a latch and then unscrew the mounting bolts and then the outside door handle bracket retaining bolt and dampening sleeve. 1. Install the bracket assembly of the latch and outside handle out of the door opening. To disassemble, unscrew the cables on the handle bracket and latch assemblies by prying off the wiring harness clip and removing the cable on the bracket and then prying off the wiring harness clip on the latch assembly. Move the parts required to be used on the new ones and reassemble by undoing the steps followed during disassembly.