This is done to the front and rear window regulator/motor. In order to take off the window regulator, remove the door trim panel and remove the door window glass. remove the electrical connector and remove the power window motor. Unscrew the tabs on the reel of cable and insert the reel into the door. Peel away the access flaps and take out the window regulator mounting nuts and push the regulator sections into the door. Install an assembly, the guide, out of the door opening. The opposite of uninstalling is installation, and to ensure that the window regulator mounting nuts have been tightened to a particular torque level. In the case of the window motor removal, the door trim panel is once again removed first. When the window is completely closed, apply masking tape to keep the glass upside down making sure that it does not fall. Unplug the electrical connector on the motor, and unscrew the mounting screws and disassemble the motor. Installation is done in reverse sequence of removal and the screws of the window motor are tightened to the required torque.