Genuine Volkswagen Cabrio Wheel Cylinder

Volkswagen Cabrio Wheel Cylinder Parts and Q&A

• Wheel Cylinder
  6Q0-611-053-B
  Q: How to remove the wheel cylinder from the brake drum on Volkswagen Cabrio?

  A:

  The Brake Drum can be removed by first washing the brake assembly using brake system cleaner and letting the excess liquid to drain in a drip pan. It is important to take the upper brake shoe return spring out of both brake shoe with a plier and then remove it to ensure that the upper ends of the shoes are not attached to the wheel cylinder. Reduce the loss of fluids by capping the master cylinder reservoir with cellophane. Unscrew the fitting nut of the brake line at the wheel cylinder, shake the line out and wipe off the fluid spilled off, and then wipe the end of the line to keep dust out. Unscrew the two bolts holding the wheel cylinders together at the back of the supporting plate off and take the wheel cylinder out, making sure that the brake shoe linings are not contaminated with brake fluid. Wipe the wheel cylinder with brake system cleaner and then remove rubber dust seals at the ends of cylinder body. In case the pistons fail to eject because of the pressure of coil springs, tap the end of the cylinder body on a piece of wood to eject. Search the surfaces of the pistons and bores of the pistons, to see whether they are scored or in contact with metal; and, in case they are, change the complete wheel cylinder assembly. In case the pistons and bores are well-kept, you can replace the seals and purchase a repair kit with the required replacing components. Unscrew the seals of the pistons, making sure that they are properly oriented, lubricate the new piston seals with clean brake fluid and put them in place with the lips facing the inside. Wipe the pistons with clean brake fluid, fit the spring to the cylinder and pop the pistons into the cylinder bores with a twisting motion. Fit the dust seals and make sure that the pistons are free to move. Make sure the backing plate and the wheel cylinder mating surfaces are clean, position the brake shoes and position the wheel cylinder. Install the brake line and screw the fitting nut a few times to begin threading; then install the two wheel cylinder retaining bolts and tighten them to the required torque, then screw the fitting nut of the brake line tighter. Take off the cellophane in the master cylinder reservoir, the brake shoes on the pistons of the cylinder must be properly aligned and the brake shoe upper return spring should be fitted properly with the help of a screwdriver. Lastly, install the brake drum and bleed the brake hydraulic system, but here one should make certain of minimizing the loss of fluid that may require bleeding the associated rear brake.