How to drain and replace the transmission filter and fluid at specified intervals on Volkswagen Jetta?

Question

Accepted Answer

The transmission fluid must also be drained and replaced at certain intervals always making sure that the job is done when all has cooled down. You will need to buy the following transmission fluid beforehand. One will need jackstands to prop the car up on, a drain pan that can hold various quarts, newspapers, and clean rags. Lift the front and rear of the car safely on jackstands, and then lift the splash shield that is under the engine, and the engine cover/air filter housing. Loose and disconnect the battery and battery tray, place a drain pan and rags beneath the transmission. With an open-end wrench, it is necessary to loosen the filter housing but leave it in place so that the oil in the housing will flow back into the transaxle. Un screw the filter element, filter housing and O-ring and remove the filter element. Wipe the filter housing and replace O-ring. Wipe the end of the new filter element with DSG oil and fit in place with its locating arrow facing down into the transaxle. Apply DSG oil to the O-ring of the filter housing, place the filter housing on the filter element over the transaxle and tighten to required torque. Working underneath the car, unscrew the transaxle shield mounting bolts and shield. Under the transaxle check/drain plug remove the plug and then allow the fluid to drain by unscrewing and removing the overflow tube with an Allen wrench. Once the lubricant has emptied, place the overflow tube back and screw it to the desired torque readings to be used in the future. Fluid is inserted by the check/fill plug hole; one special tool is provided, although a suction gun with a sloping nozzle can also be used. Gradually empty the fluid, and then, temporarily refit the check/drain plug. Having the transmission in Park and the parking brake activated, switch on the engine, press the gear selection lever through each of the ranges, taking a three to four second pause in each selection. Allow the engine a few minutes to idle then unscrew the check/drain plug, should the fluid leak, leave it to drip until it drips. When there is no fluid to run out, add fluid until it runs out. Install a new seal on the check / drain plug, re-fit, and screw it to the required torque. Install the splash shield underneath the vehicle, lower the vehicle and install it in the reverse order. Check the filler housing and check/ drain plug after driving the vehicle over a short distance.

Genuine Volkswagen Jetta Transmission Filter

8 Transmission Filters found

Volkswagen Jetta Filter Part Number: 02E-305-051-C

Volkswagen Jetta Screen Part Number: 01M-325-429

Volkswagen Jetta Filter Part Number: 09G-325-429-A

Volkswagen Jetta Filter Part Number: 09G-325-429

Volkswagen Jetta Filter Part Number: 09G-325-429-B

Volkswagen Jetta Filter Part Number: 09G-325-429-H

Volkswagen Jetta Filter Part Number: 09G-325-429-D

Volkswagen Jetta Filter Part Number: 09A-325-429

Volkswagen Jetta Transmission Filter

Volkswagen Jetta Transmission Filter Parts and Q&A

Related Volkswagen Jetta Parts

Browse by Year