On 2001 and older models, the first step is to take the housing of the front turn signal off, and use masking tape to cover the area around the headlight housing to cover the body. Then remove the covers and screwdriver the mounting screws of the headlight housing out. Gently lift the headlight housing forward and a little sideways, loosening the front grille trim, remove the electrical connectors, and pull the housing all the way out. Installation is opposite of this: To install, slide the housing back in and make sure the grille tabs fit on one side of the other and reconnect the electrical connections inside the engine compartment and and install in the same sequence. In 2002s and subsequent models, begin by unattachment of front bumper cover and the piece of plastic reinforcing it, thereafter, disconnect the wiring to the headlight. Removal of the cover headlight bolt should be done by peeling the cover then removed which is the other two headlight mounting bolts. Move the headlight housing out of the car and forward, and then install it on the reverse of the take out procedure.